Chop 10 ounces of LCP Clear Melt and Pour Soap, place the pieces in a heat-safe container, and melt in the microwave using 15 second bursts. Add shavings of the Fired Up Fuchsia Color Block until you get a bright pink shade. Add a sprinkle of Fine Silver Rainbow EcoGlitter and stir to combine. Pour the soap into the cavities of the Medium 9 Ball Silicone Mold. Let the soap cool and harden for 2-4 hours.

Remove the embeds from the mold. Remelt the remaining soap using 5-10 second bursts and fill up the cavities again. Allow to fully harden, and remove from the mold. Set aside until you’re ready to use.

Slowly and carefully add 7.8 ounces of lye to 16.5 ounces of water and gently stir until the lye has fully dissolved and the liquid is clear. Set aside to cool. Optional: Add 3.5 teaspoons of sodium lactate to help the bars harden more quickly.

Fully melt the entire bag of Lots of Lather Quick Mix until completely it's clear and there is no cloudiness. Shake the bag to mix up all the oils. Measure 54 ounces into a large heat-safe container. Once the lye water and the oils have cooled to 130° F or below (and are ideally within 10 degrees of each other), add the lye water to the oils and stick blend until thin trace.

Add all the dispersed titanium dioxide. Use a whisk to mix, then give it a short burst with the stick blender to help break up any chunks of colorant.

Split off about 400 mL of soap into 2 separate containers. To one container, add 1 teaspoon of dispersed Fired Up Fuchsia. To the other, add 1 teaspoon of dispersed Caribbean Blue Mica. Mix the colorants in with a whisk or spoon.

Add the fragrance oil to each container proportionally. Use a whisk to mix. The fragrance accelerates, so be ready to move quickly.

Grab a large spoon for each color. Spoon the soap into the mold, one color at a time, layering them in 3 different spots. Don’t worry about being too precise with your plops. When all the soap is in the mold, tap it the counter to help get rid of bubbles.

Insert the hanger into the soap against the side of the mold furthest away from you. Drag the hanger against the bottom of the mold toward you. Once you drag the hanger about 1/6th of the way, pull the hanger up until it almost breaks through the top of the soap, but not quite. Move the hanger toward you about 1/6th of the way. Push the hanger back down into the soap, and drag the hanger against the bottom of the mold and move it toward you again, moving about 1/6th of the way. Bring the hanger up until it almost breaks the top, then move it over and push it back down. Pull it until it hits the other side of the mold, then carefully pull it up and out.

Tap the mold firmly on the counter to help get rid of air bubbles. Use a dowel or chopstick to swirl the top of the soap.

Place the melt and pour embeds in the center of the soap, pressing down lightly to help them stick. Place them so there is a small amount of room between each to allow for a clean cut.

Sprinkle the top of the soap with Fine Silver Rainbow EcoGlitter. Spritz with 99% isopropyl alcohol to prevent soda ash. Do not cover. If the soap gets too hot, it could slightly melt the embeds. Allow the soap to stay in the mold for 2-3 days. Unmold and cut into bars, and allow to cure for 4-6 weeks. Enjoy!